Euroclass fire rated panels

Shadbolt_euroclass_fire_rated_veneered_panels_and_built-in_doors

Due to European harmonisation, fire testing and classification of materials used for surfaces of walls and ceilings, as controlled under Building Regulations Part B2, is being completely overhauled. New European fire tests and classifications are being introduced.

Under the current Approved Document B (2007), testing to either the old or the new standards is permitted, but in a few years time it is expected that BS 476 will be withdrawn and only the new European tests and classifications will be accepted under Building Regulations.

Shadbolt are undertaking extensive testing to the new European standards. Some of the products from our range of Class 0 and Class 1 wall panels have achieved the corresponding European Class B and Class C under test. They will therefore continue to be suitable for use where currently Class 0 or Class 1 panels are required (see Approved Document B2 Internal fire spread (linings)), and they will continue to be suitable after the changeover to the new system is complete.

Testing and classification
Harmonisation is in progress throughout the EU under the Construction Products Directive, with the aim of reducing barriers to trade by ensuring that products have been tested and classified consistently for their performance.
Building Regulations for England and Wales control the use of materials for wall and ceiling surfaces, to limit the spread of fire across their surfaces. In the past this has been controlled by classification of surfaces according to performance tests to various parts of BS 476. In the future this system will be replaced by a new Europe-wide system of testing and classification for ‘reaction to fire’. This relates to the combustibility and ignitability of a material, ie its potential for contribution to fire growth. Based on new tests, harmonised European classes have been developed for reaction to fire performance and adopted in national regulations of EU member states.

Wall and ceiling surfaces
In England and Wales, the requirements for wall and ceiling surfaces are set out in Building Regulations Approved Document B, section B2 Internal fire spread (linings).
Requirements are expressed as a classification derived from tests. Currently performance can be demonstrated against either the existing National or the new European standards, but over the next few years the European standards will supersede National standards. During the transition period regulations will refer to both sets of standards.
Performance classifications are based on a number of new tests, the most important of which is BS EN 13823: 2002 Single burning item (SBI) test. This provides a measure of fire growth rate and smoke growth rate. Based on test results the material is classified according to BS EN 13501-1: 2002: Fire classification of construction products and building elements: Part 1: Classification using test data from reaction to fire tests.

Correspondence between previous flame spread classes and the new European classes is shown below. However it is not possible to claim a European class for a product based on a National test; the European class must be based on the European tests.

_______________________________________

National class
(England and Wales)      
European class  
Non-combustibleA1
Limited combustibilityA2
0B
1 & 2C
3D
4E

_______________________________________

The new classification also takes account of smoke creation and the creation of flaming particles or droplets which might spread fire, but Building Regulations (England and Wales) Approved Document B2 does not currently set any limit for this.

Approved Document B Volume 2 Buildings other than dwellinghouses

B2 Internal fire spread (linings) requires internal linings of walls and ceilings to resist the spread of flame over their surfaces. Linings which were previously required to be either National Class 0 or Class 1 may now alternatively be European Class B-s3,d2 or Class C-s3,d2, provided that they have achieved these classes under European tests.

‘s3, d2’ means that there is no limit set for production of smoke and/or flaming droplets/particles. Appendix A describes the classes of performance and the methods of test.
The National and European classifications do not automatically equate, therefore a product cannot claim a European class unless it has been tested accordingly.