Correct storage on site is essential. Store in a clean, dry area, in the same conditions as are expected when the building is occupied. Cover to protect against dirt and risk of damage from other trades working.
Store panels stacked flat and level, on supports. Supports should be timber, covered with plywood or cardboard to avoid marking the panel surface, minimum 100mm wide x 50mm deep, across the full width of the panel. There should be three such supports, equally spaced, one across the centre and one 300mm from each end.
Veneered surfaces should not be exposed to strong light or direct sunlight as this could cause differential fading and shrinkage / cracking of the veneer.
Scheme matching of veneers means that it is essential for doorsets and panels to be installed in the correct positions.
In many cases, each panel is designed for installation in a specific location in the building or in a specific sequence, and must be hung with the correct face visible on each side – refer to instructions on the product’s Shadbolt bar code.
In matched schemes all panels are individually identified to show their intended positions, and installers must be made aware of the need to fit each one in the correct location – refer to instructions on the product’s Shadbolt bar code.
CUTTING & TRIMMING
Door panels are supplied to exact finished sizes and must not be trimmed on site.
Where there is uncertainty in wall thicknesses, adjustable split frames can be supplied to allow fixing adjustment on site.
Please contact Shadbolt in the first instance if you have any questions or queries.
Veneered panels should be cleaned by wiping with a damp cloth; where necessary a mild detergent solution may be used. Abrasive or chemical cleaners must not be used.
If veneered products should be accidentally damaged during or after installation, repair is usually feasible. However, exact matching of the veneer may not always be possible. Consult Shadbolt for advice.